基于PiCCO的目标导向容量管理在非停跳冠状动脉搭桥术围手术期的应用

来源 :中国医师进修杂志 | 被引量 : 0次 | 上传用户:emmagarden
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
目的:观察以心脏指数(CI)、胸腔内血容量指数(ITBVI)、血管外肺水指数(EVLWI)为目标导向的容量管理策略对非停跳冠状动脉搭桥术患者转归的影响。方法:选取兰州大学第二医院2017年1月至2018年12月非停跳冠状动脉搭桥术患者40例,美国麻醉医师协会(ASA)分级2~3级。将其按随机数字表法分为研究组和对照组,每组各20例。对照组监测中心静脉压(CVP)指导补液。研究组进行中心静脉置管+股动脉置管+PiCCO模块连接,应用PiCCO监测血流动力学指标,测定CVP、心脏指数(CI)、ITBVI、EVLWI,准确评估患者容量状况,以CI 3.0~5.0 L/(min·mn 2),ITBVI 800~1 000 ml/mn 2,EVLWI 3.0~7.0 ml/kg为参考值进行目标导向液体治疗。术中根据CI、ITBVI、EVLWI动态变化调整补液,监测患者心率(HR)、平均动脉压( MAP)、尿量、中心静脉血氧饱和度(ScvOn 2)、乳酸、肾功能等指标。记录两组患者呼吸机辅助通气时间、ICU停留时间、住院时间、急性肺水肿发生率、急性肾功能不全发生率及术后30 d病死率。n 结果:研究组患者组织灌注改善,尿量明显增加(n P<0.05),中心静脉血氧饱和度明显增加(n P<0.05),血乳酸浓度明显降低(n P<0.05),急性肺水肿、急性肾功能不全发生率明显低于对照组(5.0%比15.0%、5.0%比10.0%)(n P<0.05),病死率低于对照组(5.0%比15.0%)(n P<0.05)。ICU停留时间与住院时间均低于对照组(n P<0.01)。n 结论:以CI、ITBVI、EVLWI为目标导向液体治疗能有效优化非停跳冠状动脉搭桥术患者的心脏前负荷,提高心输出量,保证微循环灌注,维持机体氧供需平衡,降低并发症发生率与病死率,降低ICU停留时间与住院时间。“,”Objective:To evaluate the influence of goal-directed volume management based on cardiac output index (CI), intrathoracic blood volume index (ITBVI) and extravascular lung water index (EVLWI) in patients undergoing off-pump coronary artery bypass surgery.Methods:Forty patients (ASA 2 to 3 grade) undergoing off-pump coronary artery bypass surgery in Lanzhou University Second Hospital from January 2017 to December 2018 were selected. The patients were divided into 2 groups by random digits table method with 20 cases in each group: study group (goal-directed fluid therapy treatment with CI, ITBVI and EVLWI) and control group (conventional fluid therapy). The control group was given central venous pressure (CVP) monitoring rehydration, and the study group was given PiCCO hemodynamic monitoring indicators. The CVP, CI, ITBVI and EVLWI for fluid management were measured. Accurate assessment of volume status of patients was done. The study group received goal-directed fluid therapy based on CVP, CI, ITBVI and EVLWI, with the goal of CI in the 3.0 to 5.0 L/(min·mn 2) range, ITBVI in the 800 to 1 000 ml/mn 2 range and EVLWI in the 3.0 to 7.0 ml/kg range. The heart rate, mean arterial pressure (MAP), urine volume, central venous oxygen saturation (ScvOn 2), lactic acid and renal function were monitored. The ventilator withdrawal time, hospitalization in ICU, length of stay, incidence of acute pulmonary edema, incidence of acute renal failure, mortality of 30 d after surgery were recorded and compared between the two groups.n Results:Tissue perfusion and urine volume of the study group was significantly improved compared with that of control group (n P<0.05). ScvOn 2 of the study group was higher than that of the routine group (n P<0.05). The concentration of lactic acid of the study group was lower than that of the routine group (n P<0.05). The incidences of acute pulmonary edema, acute renal insufficiency and mortality of the study group were lower than those of the routine group (5.0% vs. 15.0%, 5.0% vs. 10.0% and 5.0% vs. 15.0%), and there were statistical differences (n P<0.05). The length of stay and hospitalization in ICU were both lower than those in the control group (n P<0.01).n Conclusions:Goal-directed fluid therapy based on CI, ITBVI and EVLWI can effectively optimize the cardiac preload of patients undergoing off-pump coronary artery bypass surgery, improve cardiac output, ensure microcirculation perfusion, maintain the balance of oxygen supply and demand, and reduce the incidence of complications and mortality.
其他文献
随着铁路运输的发展,铁路供电工程车工作平台出厂设计的3种工作区域定位方式,已不能满足生产现场实际需要,存在安全隐患.通过研制定位开关,改造电路后实现禁止平台旋转的第4
针对目前自动导航插秧机通过车载终端进行路径规划,不能灵活、实时调整路径的不足,基于云技术和移动物联网技术,构建无人驾驶插秧机远程路径规划系统.该系统由云服务器、远程
打桩机属于桩工机械设备,目前市场上的打桩机一般仅适用于地质地耐力较好(一般地耐力> 0.15 MPa)的施工场地,对于地耐力较小(地耐力<0.12 MPa)的施工场地,如临湖、临江、临海及
某型发动机机匣通常采用的连接方式是螺栓连接,螺栓连接的可靠性与稳定性对机匣力学特性有着较大影响.通过建立机匣与螺栓的有限元分析模型,研究螺栓预紧力对机匣螺栓连接结
目前,盾构在施工过程中的故障问题日益凸显,维修过程中逐渐暴露出维修性设计不足的问题.基于De|mia桌面式虚拟维修技术,提出盾构虚拟维修仿真评价实施方案,通过确定维修任务
分析发动机缸体接合面表面粗糙度与接合面密封性的关系,介绍表面粗糙度测量方法及轮廓最大高度、不平度平均高度、轮廓平均算术偏差3种表面粗糙度测量参数,分析各参数之间的
针对结构多轴动态加载过程中的同步稳定性问题,介绍几种同步加载的控制模型,通过对动态试验结果进行分析,得出造成结构单元多轴加载不同步的原因,给出进一步提高同步稳定性的
临界距离法是评估缺口件疲劳寿命的重要理论方法,但是该方法没有考虑到不同位置处的应力对损伤参量贡献不同的情况.建立一种修正模型来预测缺口件的多轴疲劳寿命,该模型在临