DIRECT DIGITAL DESIGN AND SIMULATION OF MESHING IN WORM-GEAR DRIVE

来源 :Chinese Journal of Mechanical Engineering | 被引量 : 0次 | 上传用户:feier068
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
A direct digital design method (DDDM) of worm-gear drive is proposed. It is directly based on the simulation of manufacturing process and completely different from the conventional modeling method. The loaded tooth contact analysis (LTCA) method is analyzed, in which the advanced surface to surface searching technique is included. The influence of misalignment errors and contact deformations on contact zone and transmission error (TE) is discussed. Combined modification approach on worm tooth surface is presented. By means of DDDM and LTCA, it is very convenient to verify the effect of worm-gear drive’s modification approach. The analysis results show that, the modification in profile direction reduces the sensitivity of worm-gear drive to misalignment errors and the modification in longitudinal direction decreases the TE. Thus the optimization design of worm-gear drive can be achieved prior to the actual manufacturing process. A direct digital design method (DDDM) of worm-gear drive is proposed. It is directly based on the simulation of manufacturing process and completely different from the conventional modeling method. The loaded tooth contact analysis (LTCA) method is analyzed, in which the The influence of misalignment errors and contact deformations on contact zone and transmission error (TE) is discussed. Combined modification of on worm tooth surface is presented. By means of DDDM and LTCA, it is very convenient to verify the effect of worm-gear drive’s modification approach. The analysis results show that, the modification in profile direction reduces the sensitivity of worm-gear drive to misalignment errors and the modification in longitudinal direction decreases the TE. Thus the optimization design worm -gear drive can be achieved prior to the actual manufacturing process.
其他文献