在3M4630磨球机上对钢球进行精磨和研光时,传统的加工方法是,使送料盘按顺时针方向旋转(图1),并在转动板上车沟,工作时,钢球从送料盘通过分配器,直接碰击到转动板的板沟并产生碰撞力P,此力在水平线上的分力P_1给钢球一个反作用力,使钢球弹回。冲击力越大,这种反作用力也越大,阻碍钢球顺利地进入沟道,使之产生短暂的停留,再加上转动板的离心力作用,使钢球不能按直线直接弹回到分配器的沟道上,而是拐了一个弯碰到分配器的隔板上。若隔板因装配不牢有松动现象或是磨损 In the 3M4630 ball mill on the ball grinding and polishing, the traditional processing method is to make the feed plate clockwise (Figure 1), and the turning plate on the ditch, work, the ball from the feed Disk through the distributor, directly hit the board of the rotating plate groove and the collision force P, the force in the horizontal component of force P_1 a reaction to the ball, the ball bounce. The greater the impact force, the greater the reaction force, hinder the smooth ball into the channel, resulting in a short stay, coupled with the centrifugal force of the rotating plate so that the ball can not be a straight line directly back to the dispenser Instead of turning on the channel, it hit a corner and hit the divider of the divider. If the separator is loose due to loose assembly or wear